Does the facet station come with quad rails and Magpul clips?
If I had a nickel for every search I've done for a https://www.alliedelec.com/nte-electronics-inc-nte5324/70215809/?mkwid=sAa7dMZ7e&pcrid=30980760979&gclid=Cj0KCQjw5arMBRDzARIsAAqmJex_FBBYeA5ne8MV69AFvdIy0qG-opCSyx5pEKG_JiTqx2m-qLhdaA0aAgdNEALw_wcB on here...
Guessing that's sarcasm, emac. This is a bunch of equipment for anyone interested in turning their finds into art, etc.
A bit. I'd rather not see this place turn into just classified ads plugging businesses, but someplace to go for good information. Perhaps you could share some pieces you've done, some helpful commentary on others' questions, or some details of the equipment and it's capabilities. Featuring a $5 component first did give me a chuckle though. Best of luck to you.
I talked with the site owner before posting and 'no worries' ... If you're not interested, don't look. Pretty easy.
So it hasn't produced anything good for you to share or highlight in this marketing campaign? Sorry to hear that. Good luck with the sell.
Chill out Eric! He's only trying to sell some equipment he acquired from family and was give prior permission from Dan through an e-mail.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)